Solar Fountain Pump

Shopping for a new solar fountain pump should not be taken lightly if you pick a pump that doesnt fit your system or that is cheap and is meant for outdoor use you may end up with a poor performing water feature or fountain. Whatever you are using the solar fountain pump for.  Keep in mind that when you buy the pump you will want to knote the PSI and hose size for your fountain and what it can handle.

« Previous12345...2122Next »

I recommend getting as much as you can, but you will want to make sure you have the solar panels to power the solar fountain pumps you just purchased.  Here is a great tip, mount your solar panels in nearby trees or out of the way where they will get the most sunlight possible, you can run a chord to your feature easily through PVC. Just cut a small line and tuck the piping with the chord under the grass(make sure its water proofed at the seems.

Videos on Solar Fountain pumps

Solar Water Pump Demo

6W Solar Panel Solarmodul Panneau Solaire + 3W Fountain Pump Teichpumpe Pompe d'étang 400 l/h

Questions about Solar Fountain Pump Problems

Question:

How can I make my own aquarium filter, using a submersible fountain pump?

Is that possible?
I don't want to buy one. At least, not for more than a few dollars used.

I was also thinking: If I knew how to do it, I could make one that looks much better than those store-bought filters.

So, I can either a) pump the water up outside the tank and through a series of filters before it spills back into the tank or b) encase the pump in sponge so it sucks the dirty water towards it and the dirt gets stuck?

Are there any other methods?

Answer:

This would have to be for a good-size aquarium. The only way I can think of doing it is to place the pump on the floor of a plastic box that is filled with plastic filter balls and/or a custom-fit filter pad (sold at Lowe's in the Garden/Pond section). This plastic box would have to have a secure lid (maybe tied on) with a hole cut out of the middle of the lid for the spout (or upright tube) of the pump to stick up and through, plus at least a dozen other quarter-size holes. This box would sit on the floor of the aquarium and the height of the spout would have to be just above the water level. Your submersible fountain pump may need an extension tube to make it tall enough. Also, the pump would have to be turned to it's lowest setting so that it just trickles out of the top of the spout and, in turn, aerates the aquarium water.